![]() The arm design is essentially a simple one. The arm also includes steel bearings into tungsten steel cups while the low friction yoke is massy to help bass and dynamics. Care and attention is required which is not helped by the rambling, rather indistinct manual the arm suffers in the same way. ![]() Turntable construction was straightforward but involved. If you take the platter off, you will see that it is held together with a single bolt which is the position of the pivot. Time has also been utilised to source the bespoke motor and bearing consisting of a hardened steel ball running on a tungsten carbide plate. The platter is made from a carefully constructed acrylic with low internal stresses. The mass is present in the three chromed, steel pods and the slice of steel alloy situated between the two acrylic sandwich slices on the plinth. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |